When was the last time you had to travel to site to repair a minor fault, or spent hours on the phone to someone on site to troubleshoot a basic problem?
With a remote access gateway fitted to a compatible PLC/HMI control system, you can not only view and control your system from anywhere, but tweaks and changes to the PLC and HMI software can be remotely uploaded and tested.
What’s involved in setting up remote access?
Remote access can be fitted and set up in the factory, or retro-fitted to a control panel in the field. A remote access gateway needs to be installed, and an Ethernet connection established between the gateway, PLC and HMI.
For retro-fits, additional hardware such as an Ethernet switch and PLC communication card may need to be added.
How much does remote access cost?
The good news is that the whole solution is not expensive.
Depending on the capabilities required, we can provide the hardware, programming, setup and training – contact us for a quote. If the solution saves you one trip to a remote site, it will have paid for itself.
Any ongoing costs?
The remote gateway connects to the Internet via a 4G/5G data connection, similar to a mobile phone. As such it requires an active SIM card with a M2M (machine to machine) data plan. These are typically low-cost. We typically recommend our customers arrange the SIM card, so they can remain in control of the facility.
What actually does remote access look like?
You can connect from a smartphone to a control system, even one over 3000 km away. Once set up, you can simply tap on the relevant icon to initiate a connection. The connection will take a few seconds, and your HMI view will open up. From here, you can view exactly what your system is doing. You can press buttons and change settings exactly as if you were standing in front of the control panel. Once you’re finished, simply disconnect. The control panel will continue running exactly as you left it.